International Journal of Industrial Engineering and Management

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 7 No. 3 (2016)
Original Research Article

3D Technology in Production of Sealed Containers for Chemical Industry Devices

FULL TEXT ARTICLE (PDF)
  • Nicolay P. Miducov,
  • Maria A. Fadeeva,
  • Alexey A. Tikhonov,
  • Pavel V. Kaurov,
  • Victor S. Kurov,
  • Pavel A. Gashin
Nicolay P. Miducov
Saint Petersburg State University of Industrial Technology and Design
Bio
Maria A. Fadeeva
Saint Petersburg State University of Industrial Technology and Design
Bio
Alexey A. Tikhonov
Saint Petersburg State University
Bio
Pavel V. Kaurov
Saint Petersburg State University of Industrial Technology and Design
Bio
Victor S. Kurov
Saint Petersburg State University of Industrial Technology and Design
Bio
Pavel A. Gashin
Saint Petersburg State University of Industrial Technology and Design
Bio
DOI: https://doi.org/10.24867/IJIEM-2016-3-114

Published 2016-09-30

abstract views: 17 // FULL TEXT ARTICLE (PDF): 0


Keywords

  • containers for devices,
  • leak tightness,
  • 3D-technology,
  • chemical industry

How to Cite

Miducov, N. P., Fadeeva, M. A., Tikhonov, A. A., Kaurov, P. V., Kurov, V. S., & Gashin, P. A. (2016). 3D Technology in Production of Sealed Containers for Chemical Industry Devices. International Journal of Industrial Engineering and Management, 7(3), 125–128. https://doi.org/10.24867/IJIEM-2016-3-114

Copyright (c) 2023 International Journal of Industrial Engineering and Management

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

Chemical industry today needs new high-tech and cheap sealed containers for devices. The material on the usage of 3D technology in production of device's drum is presented in this article. Samples of device's containers for chemical industry were fabricated by means of 3D printer with different parameters of the 3D printing (thickness of the drum and layer's height). The leak tightness of device's containers was tested under the air pressure. The optimum regimes for 3D printing of sealed containers for devices correspond to minimum possible thickness of sealed containers. The obtained results can be used in low cost production of chemical devices with complex body shape.

 

Article history: Received (03.12.2015); Revised (17.06.2016); Accepted (30.07.2016)  

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)